How to iron trousers with arrows and without them

What to do before ironing

1. check the label

Make sure that the pants can be ironed.

2. wash trousers

They must be clean, because under the influence of high temperature may vestsya any spot in the fabric and bring it to be impossible.

3. Prepare a water spray bottle

To smooth out wrinkles, they should be sprayed.

4. Mark clean towel

After ironing his trousers may appear luster, which should not be. To avoid this, put between the product and the iron wet towel. It will also help get rid of wrinkles difficult if you do not spray.

5. Put the ironing board

iron pants best for her.

What temperature to choose

As a rule, any product has a label with care requirements. The special character will tell you how much you need to heat the iron, so nothing to spoil.

If there is no label, consider the type of fabric:

• Cotton - 180-220 ° C;
• Flax - 215-240 ° C;
• Rayon - 150-180 ° C;
• Wool - 160-170 ° C;
• Polyester - 140-155 ° C;
• Silk - 140-165 ° C;
• Mixed - Choose the temperature of the kind of fabric to which it is lower.

How to iron

Set the ironing board is convenient. Fill the water tank in iron (you may need to pair), select the desired temperature and leave iron heat.

Start with the pockets

The pockets can be made of thin fabric, which requires a lower temperature. Turn them inside out and place it on the board so that your leg is not hampered.

Gently iron the pockets of his trousers, while the folds disappear. This will help prevent new wrinkles on the fabric in the future.

Go to the belt

Leaving his pockets inside out, pull the leg on the ironing board to the belt itself. Pressing iron, but without moving them back and forth, walk around the waist area from all sides, gradually scrolling leg on the board.

Hold the iron on the cloth a few seconds, but be careful not to burn it. If there are unwanted wrinkles, flatten them and otutyuzhte again.

Repeat with the second leg.

What happens next depends on whether the arrow of your trousers or without.

Iron the legs without hands

Straighten one leg to pieces and put it along the board face up. Smooth hands all the little creases.

Begin with the upper ironing of the trousers. Push the iron and smoothly moves to the bottom, moving from one seam to another.

If the folds do not give in, turn on the steamer and bring an iron to the problem areas or use a spray bottle.

Otutyuzhte other side and repeat with the second leg.

Make arrows

Take one leg pants and fold so that the outer and inner seams match. Put on the ironing board, the inner seam down. Secure with pins or terminals: There should be no wrinkles and roughness.

Sprinkle with water or put a wet towel on top and start stroking. Push the iron and move it slowly so as not formed folds.

Walk along the fold lines - your future shooters - again, pressing their iron for a few seconds and including this point pairs.

Otutyuzhte other side and repeat with the second leg.

Do not allow the arrow to waistLeave 7-10 cm indent, if the model does not suggest otherwise trousers.

Life hacking: the arrow will remain longer if before ironing rub them with soap lump.

Allow to cool pants

Do not wear or remove the cabinet just ironed trousers. Let them cool for a few minutes.