How to fix the iPhone cable

Apple accessories have a disproportionate price and not always of high quality. For example, the original cables of the devices are very easily damaged. Today we'll show you how to save the victim wire, and thus save a few thousand rubles for the purchase of replacement.

Today let's talk about the iPhone with thin wires Lightning-connector. As is well known, they are not always happily. Primarily, these wires have poor insulation. And when it comes in completely useless at the crease, around the wire end comes. Unfortunately, the Cupertino-based company's device is built protection against the use of non-original accessories (and with it, we will look at one of these materials). Therefore, keep the wire - the main task. The key word in this article - the so-called "shrinking."

Unfortunately, I'm not a fan of iOS, so the original (and the more corrupt) cable for charging and data transfer I have not found. The nearest shop found a more useful generic USB cable with three connectors: microUSB and a pair of Lightning-connectors of the old and new versions. Cable variety, but ...

... mess it up is a snap. Isolation on a fake cable is very similar in the insulation properties of the original. So do a couple of notches and simulate common to damage to the cable is easy.

And now it was the turn of repair. To do this, we will use the most common heat-shrinkable tube of suitable diameter. By the way, this thing is sold in any hardware stores, where they sell including appliances. You just need to tell the seller the word "shrinking."

For those who do not know: heat-shrinkable tubing It represents a thin-walled plastic tube inner diameter of 1 to 110 mm for wires and other electric insulation pieces. Upon heating (desired temperature ranges from 70 to 110 degrees), the tube is compressed approximately twice. After heating the heat-shrinkable tube bends repeats all the starting wire. She sits down as tightly as possible without breaking - if well selected diameter, almost tightly.

In this case, the arm came across like this, 6 mm (pull the plug on its problematic, but a larger size will be more shaky structure).

Cut the required length of the tube piece (calculation of the start wire and insulation damage to the edge, with a margin of centimeter). Carefully put on the phone to the connector and fix by hand or electrical tape.

After we warm up over any hot object: gas or electric hob plate, lighter, gas burner. Be careful shrinkable material as wire, does not tolerate the high temperatures and the more open flame. Enough hot air rising from the fire. The output is restored cable.

The manual is written based on a curious video in the comments under which it became clear that Russia's population is shrinking either unfamiliar with or do not realize it does not apply direct appointment.

The following publications will learn to remove the display from the phone to get to the battery, and dry drowned phone. If you want to see the material to another subject you're interested, please write in the comments.