DIY: How to Make a Waist Case for smartphone or music player of old jeans

Jeans like it. Well, almost all. And the old was overlooked in the attic a couple of jeans - someone is favorite, pureed into holes panties, someone entirely new, unworn (because someone gently podnabrat thousand grams) - certainly there. Today, I suggest you not revolutionary, but quite an interesting idea of ​​how to usefully apply the old jeans. And do not feel sorry for them! Admit it already fairly, that they would still be lying dead load on the far shelf and would never have seen the light at the end of his life linen.

I propose to be very bloodthirsty and put an eye on the steepest part of the jeans - leather label that is located on the back of his belt. At this stage, we need: a ruler, pen, pencil or marker, preferably sharp scissors.

Attach the label to the gadget to navigate on the necessary size of the case. It is important to remember that on both sides of the tag need to lay additional space for buttons and seams. Piece of severed tissue should be about 25 cm long and 8 cm wide.

Now is the time to take branded tag. This may be a label indicating the size or the rules of the garment care. In any case, remove them with a seam ripper or scissors.

this is called overlozhit or neaten - that nothing be fluffed and dispersed, cuts a piece of denim to be processed. You can do this manually, but you can entrust this work to a sewing machine, putting it on the appropriate mode.

Neaten the edges, you need to sew up the case on one side. To look all neat and beautiful, turn the fabric inside out to him, fold in half so that converged on the front face, make the seam on one of the sides. Try to sew as close to the edge, so as not to waste precious jeans.

After that, remove the fabric. Now you can start to cross-link the other side. Where you have to try, because the fabric is much thicker and may have difficulties with the passage of the needle therethrough. In the end, everything should turn out like the picture ↓

To protect your gadget from falling out of our case study, it is necessary to provide for its closure. You can sew along the edge of the usual button (or a button). But they are tight enough to open and close, which is not convenient. I would like to get a player or phone from the case could be one left.

So use sew (secret) key. We sew two buttons - so it will be convenient and secure. If you are afraid that the buttons will scratch your gadget, then replace them with Velcro to sew are no less simple.

Done! The beauty of this case study is that it can be used:

A) as a normal storage case, carry and protect the gadget from damage:

B) Carrying gadget on the belt by the presence of loops of the case from the back side, which allows to thread the strap through it: