How to stick a protective film without bubbles

Why in the salons of the protective film on the phone or tablet glue evenly (but for the money), but it does not work at home, no matter how hard you try? Because you're doing wrong!

Step 1. Prepare the room

It is impossible to avoid the mounds when placing the film on the screen devaysa if the room a lot of dust. If not ready, microdebris nalipnet protective coating to the surface and forms bubbles nevygonyaemye. So before you begin to elevate your phone or tablet, you must consider the following:

• In the living room a lot of furniture, textiles and other dust collectors - we still do not fit. The best place to film labels - kitchen or bathroom. True, there will have to bear all the towels, tablecloths and mats.
• In dry air, light specks floating around. This means that you need to work a spray. The dust gets wet, potyazheleet and falls to the floor.
• Wipe with a damp cloth every horizontal surface and wash the floor. Finish the room freed of dust.

Step 2. Prepare tools

Now place it on the prepared surface tools. In addition devaysa and a protective film, we will need:

• fluid to clear the display, an antistatic or a conventional alcohol
• credit card or thick plastic card,
• microfiber cloth (often comes bundled with the film)
• stationery tape.

Before work, remove hair, choose the right clothes and wash your hands with soap and water. So we we reduce to a minimum the risk of excess dust.

Step 3. Prepare the protective film

If you purchased the film specifically for your devaysa, skip this step. If you bought a universal version, it will be necessary to work with scissors or a knife stationery. But to begin with - to determine the exact contours of your phone or tablet the most convenient way:

• If left factory film, which was covered just bought a device, affix it on top of the marking grid and cut out in outline.
• Otkserokopiruyte phone. The image in full size allows perfect fit film form.
• Lay a sheet of film over a universal gadget mark edge marker or marker.
• Cut film, departing from the screen of about 1 mm. This will help to evenly place the protective cover on the phone.
• After giving the film forms do not forget to make holes for the buttons and speaker.

Step 4. Degrease the surface of the screen

Using the cleaning liquid for displays, an antistatic or an alcohol, clean phone screen. Microfibre cloth, remove any small dust particles. After this procedure, do not touch the screen with your fingers or hit-sleeved clothes.

Step 5. Stick the tape

Each protective film consists of three layers, upper and lower tabs, labeled 1 and 2. The first layer is removed to connect with phone film. The second - to open the final gloss or matte finish.

• Turn the first film side down and align the screen from the device. Check whether all the twists and technical holes.
• Take a deep breath, ensure that no shaking hands, and separate the first layer from the protective film. From this point on, do not touch her hands hold the edges.
• Carefully attach film to the screen, starting from the edge of the (narrow or wide) and helping himself with a plastic card edge.

• Gradually place the film entirely on the screen. The resulting air bubbles expel card from the center out. Since we have taken all measures to remove dust from the work area, nevygonyaemyh bubbles will not.

• Upon completion remove the second layer with a protective film.

Step 6. Remove missing motes

If the wretched speck of dust still fell on the screen to remove them help stationery tape. Cut two strips of it. One piece of adhesive tape lift the protective film, and a second remove lint.

It remains to put the tape in place and re-smooth the plastic card.

Done! The transaction is completed, you are great! Now you can take your phone safely camping or on the beach: nothing will harm the screen fashion device.