The original case for the stick with his own hands

Welcome to all beginners as well as experienced layfhakerov this site!
We have electronic journalIn which we write different interesting articles about useful gadgets and unusual concepts. And just look into the future, or do really interesting, beautiful and useful. Read the next article Ezine.

USB-stick today have virtually everyone. But with all the diversity, range of enclosures such devices is rather limited. And, why not make a case for the stick to? It's not as difficult as it seems, we just have to spend quite a bit of time. But you will become the owner of a unique gizmos.

Let's get started! Following the steps below will make case for our USB-stick from blocks of children's designer Lego.

That's how it will look

Tools and materials
• penknife
• Pliers
• A few Lego blocks
• Super glue
• Sandpaper
• polish metal
• Flash drive

Step 1. The basis of the housing

Internal elements broken out

Boards come in different sizes USB-memory. We will be packaged quite a large fee. Therefore, we will need a Lego bricks of size 6 × 3 cylindrical seat member (we shall call them "points").

Penknife need to prune all the internal walls of brick, and then break down them with pliers.

Two low-profile brick dimensions 4 × 2 and 2 × 2 "points" use to create the cover. Also for the cover member 1 need low profile × 6 "points" (the lid can be used for other combinations of parts designer, and can be simply take exactly the same brick as for the housing base (6 × 3), and accurately cut the jigsaw its upper part parallel to the horizontal plane).

Use superglue glue the lid member to receive the item size of 6 × 3 "points".

Step 2. Installing the card

in the housing board

At the end of the body cut out a groove for USB-connector, and after a little adjustment with the help of a penknife set the device into the body.

Step 3. board mount

Fill the body with silicone

Puts a trimming brick to the bottom housing and ensure that payment is parallel to the horizontal plane and not pressed. Fill all the remaining space in the housing transparent silicone, compacting it to reduce the possibility of any movement flash card inside the case.

It is important to use clear silicone, because through it will have to shine indicator LED.

Step 4. Gluing and polishing

We clean the brink

Polishing different abrasiveness

To between the lid and the body did not have slots, take the sandpaper, put it on a flat surface and align it to the bottom of the lid plane.

After we cover superglue stuck to the body, with the same sandpaper remove burrs and smudges of glue to the side faces of the housing.
Then finally polish body polish.

Step 5. completion

housing is ready

Compare your exclusive and mass consumer goods

It looks stylish!

But this creative potential to create exclusive flash drives are not exhausted. Conversely, the kinds of cases for them can be infinite.
See what others have done yourselfers.

via

Do you have an original style flash drive? What methods of individualization of the mini-media know you?

Meanwhile, in a mini-magazine there are still some unreadable curious visionary video about the future of medicine; Gadgets - landline and cell phone tourist bottle for water disinfection. Read, subscribe to the magazine and do not miss anything!