How do I configure the router without the help of a specialist

1. Connect the wires

Plug the internet cable to the WAN port (or of Internet) your router (also known as a router).

Connect the router to your computer: one end of the power cord into any of the LAN-port router, and the second - in connector network PC card. Instead of cable, you can use a wireless connection, but at the stage of setting better not to do.

Connect the router to the wall outlet. If your device has a power button, click on it. Then wait a minute or two, so that the router had to boot.

2. Check the internet work

If your router has been pre-configured provider, or get the settings automatically, the Internet can earn a few seconds after connecting the router to a PC.

To check, run the browser and try to open multiple sites. If access to web resources do not have any problems, you can skip the fourth paragraph of article.

3. Enter the menu of the router settings

In the address bar of your browser, type 192.168.1.1 or 192.168.0.1 and press Enter. One of these IP-addresses should lead to the router's settings menu. If both options do not work, locate the IP-address in the documentation for your router model and try to enter it.

When the login page window will appear in the browser settings, the system can request a login and password. Most often, when the primary connection is one word for both fields - admin. Less as a standard password routers manufacturers use a combination of 1234.

If necessary, you can find your login information in the instructions to the router or on the provider's website. Or try an alternative way of.

4. Set up an internet connection

If the Internet has not yet been earned, the router needs special settings. What parameters you need depends on the specific device model and Internet service provider. Universal configuration does not exist. To get the right instructions, check the website provider or request it from support.

Procured guide to setting up your model, follow its prompts. If in the process you have set up and connect to the internet and home Wi-Fi network, you can skip the fifth paragraph of the article.

5. Configure the home Wi-Fi network

that protect network Wi-Fi, it is important to choose the correct security settings.

In the settings menu, find the section in charge of the wireless network (see. the documentation for your router model). Here, be sure to set a secure password (you will need it to connect to your router device for Wi-Fi), and select WPA2-PSK as a means of protection.

Do not forget to save your settings change.

6. Change the password to log into the router settings

In any case, better to limit unauthorized access to the router's settings menu. If the router is still protected by a standard password, replace it with their own.

Locate the preference section, which is responsible for security (see. the documentation for your router model) of the device, and enter a new secure password here. Save your changes.

If your computer has Wi-Fi module, after the completion of setting the power cord can be pulled out of the PC and connect to the router wirelessly.

7. Install the router in an optimal location

Ideally router should stand in the center of the area in which you are using Wi-Fi. Thus the signal will be equally available to all connected devices.

The lower the walls, furniture and other obstructions between the device-receiver and the router, the wireless network is working better.