How to make a cute snowman with his hands: 20 cool ideas

Fashioned winter character of the paper, thread, cups, caps, socks and wool.

How to make a snowman sock

What do you need

• White socks;
• scissors;
• white thread;
• dry rice;
• bright fabric strip;
• glue;
• 2-3 bright buttons;
• 2 black writing pins;
• 1 orange writing pins.

How to do

Cut in half a sock on the foot near the heel.

Part of a toe postpone until the side. Remove the top half of the sock inside out. Above the heel knit fabric strong knot.

Turn back sock.

Fill a sock with rice to the gum.

Give the shape of a snowman figure, slightly squeezing the sock just above the middle.

Tie a knot on top of a rubber band.

Tie shape in place of the neck snowman future.

Tie a scarf around the neck of the fabric strip. The lower part of the second half of the toe tuck a few times. Put the resulting cap on the head of a snowman.

Belly stick a few buttons. At the site of the eye, plug pins with black ball.

Make the nose, under the eyes sticking orange pin.

What other options are there

Very cool look snegovichki of terry socks. In this video, performance technique is slightly different from the previous one, but the type of material that does not depend on:

Insulate snowman blouse and hat of colored socks and make eyes of buttons:

And, you can not make a figure of two and three "snow" balls:

How to make a snowman out of cups

What do you need

• Large plastic cups (e.g., volume 450-500 ml);
• stapler;
• small plastic cups (e.g., volume 150-200 ml);
• illuminantPowered by batteries - optional;
• glue gun;
• black foamiran or cardboard;
• a pen;
• scissors;
• orange cardboard;
• scarf;
• hat.

How to do

Attach two large cups to each other and connect them in the middle of a stapler.

Attach a few more cups. They will begin arcing.

Continue adding plastic utensils and a stapler to fasten it, until you have a circle.

Then start making the top one more series, combining glasses with lower and with each other.

Finish the second row. The figure should naturally tapering upwards.

In the same manner, add a third row.

Take the fourth row and attach one cup in the middle. Depending on the amount of cups you can get more or less rows, but the principle remains the same.

Turn the figure upside down. Add a few more rows of cups, narrowing the figure upward. You should get a bowl.

You can leave a small opening at the top. If you put a snowman down hole, it will be more stable. In addition, the inside will be easy to attach any lighting fixture powered by batteries.

In the same way make the ball of the little cups. Secure them via glue-gun.

Cut from black cardboard foamirana or five circles. For the convenience of the neck of a small circle of the cup. Glue the three buttons of the lower part of the snowman, and two eyes on top.

Fold the orange cardboard so as to obtain something like a carrot. If you need to use glue. Attach the nose under the eyes.

Put on a snowman hat and scarf. If necessary, fix these accessories glue. In place of oral paste curved strip foamirana or paperboard.

What other options are there

Make a cute winter character can be and from one cup:

How to make a snowman made of threads

What do you need

• 2 balloons;
• Scotch;
• PVA glue;
• water;
• white yarn;
• needle;
• black cardboard;
• pen or pencil;
• scissors;
• paper clips;
• gold ribbon;
• Orange paper;
• eyes for toys;
• glue gun;
• large black buttons;
• red cloth;
• 2 sprigs.

How to do

Inflate the balloons. One of them has to be a little bit more. Glue them with tape to form a snowman. Splice tie threads.

In a bowl, mix PVA glue and water in equal proportions. Thoroughly soak the yarn in the resulting solution and wrap her balls. Place the thread randomly and do not cover the full balls. Leave a small opening at the bottom that can stand snowman.

Leave piece to dry. This process can be accelerated by using a hair dryer.

Punctures the balloons with a needle in several places and take them out through the holes.

Cut from black cardboard narrow, long rectangle. Make a lot of large parties of vertical incisions and bend them.

Glue the strip into a tube. Secure the board with staples at a time.

Cut out a small cardboard circle the diameter of a black tube and a great one. Lubricate the curved part of the tube with glue and glue circles on both sides. Decorate hat gold ribbon.

Draw on the black cardboard and cut out smiling mouth. Glue on the bottom of a piece of orange paper. From it is cut square and twist the cone. Make at its base a few short vertical incisions and bend the paper. This will be the nose.

Attach to the snowman eyes, nose and mouth. This can be done using PVA glue or a pistol.

Glue on the bottom of the snowman buttons. Put him a scarf of red cloth. Insert sprigs in place of hands and secure with hot glue. Attach the head hat.

What other options are there

This snowman can be made of three "snow" balls:

Cute winter character is obtained from the pompons:

How to make a snowman from paper

What do you need

• 2 sheets white paper A4;
• scissors;
• glue;
• thread;
• stapler;
• colored paper;
• pencil.

How to do

Cut a piece of white paper across into two parts. Put one of them in half vertically. Then bend the paper in half twice more in the same direction. You will have a narrow strip.

Expand the paper. On one short side fold the sheet so that the first fold region touched.

Turn the paper over and fold the top narrow strip, resulting in the previous step. If you have difficulty, see video instructions below. Continue to fold the paper in the same way each time reversing the sheet. You will get an accordion.

Do the same with the second part of the paper. Grease one side of the accordion with adhesive and stick to it a second accordion. Tie a knot in the middle.

Glue sides of the preform so that they form a circle.

Halve second sheet of white paper. Every part of the accordion fold and glue as the previous part. Crop accordion folded about 1 cm.

Tie the thread in the center of the circle and glue.

Place the edge of the bend of a small circle on a large and secure with a stapler.

Cut from black paper hat. Over fields paste pink stripes, or other colored paper. Coat the glue almost all of his hat on the back side and "put" on the head of a snowman.

Of black paper cut two circles, but from the white - two more smaller ones. Glue the white parts on the black and attach the eyes under the hat. Of Orange paper-cut carrots and make it a nose snowman.

Cut two strips of the same paperAs the band on the hat. On the edge of a triangle cut out to the edge of the box looked like. Glue this strip to another vertically at a slight angle. "Put on" the resulting scarf around the neck snowman.

What other options are there

A slightly different snowman of paper accordion:

Snegovichok spring strips of paper:

This video shows you how to make three-dimensional piece of paper circles:

print template and make Olaf - cheerful character from the cartoon "The Cold Heart":

Here is a figure made in the technique of origami:

And in this tough snowman made of papier-mache can put Christmas gifts:

How to make a snowman made of cotton

What do you need

• wool;
• water;
• soap;
• PVA glue;
• brush;
• toothpick;
• orange pen;
• red cloth;
• red yarn;
• scissors;
• glue gun;
• black beads;
• 2 sprigs.

How to do

Form a ball of wool, slightly flattening it on each side. Good lather hands and rolls them blank so that it compacted. If needed, add the cotton that the ball was flat.

Make another smaller ball. When they are dry, cover them with glue, mixed with a little water. Again dry.

Wrap a bit of cotton wool on a toothpick to form a cone. Grease the adhesive solution, dry and color the orange marker.

Cut a rectangle of red cloth or trapezium. Grease the bottom of the hot glue and a little bend upward. On the other hand the adhesive side of grease and adhere thereto by another region of tissue.

Remove the piece and tie a knot around the top, to get a cap. Make a few cuts in the tip to make it look fluffy.

Glue two cotton balls to assemble the snowman. Attach the cap and spout.

Of beads and buttons of your eyes do. Add a scarf of red cloth and handles on the sides of the branches.

How to make a snowman out of the covers

What do you need

• 3 small iron cover;
• White paint;
• brush;
• white ribbon;
• glue gun;
• orange pen;
• black pen;
• black cardboard;
• color ribbon;
• button;
• scissors;
• brilliant colored cardboard or tape.

How to do

Paint the inside of the lid and the outside white paint. Let it dry thoroughly.

Glue the two of them in a row to the white ribbon.

The third cover tip glue strip.

Then again lubricate the third cover with glue and attach it next to the second. The detailed process is, in the video below.

On the reverse side draw spout orange, black eyes, mouth, and buttons.

Tie a colored ribbon around her neck and glue it on the button. The excess part of the cut. From black cardboard cut out a small hat, decorate a strip of glossy cardboard or tape and glue to the snowman head.

What other options are there

Snegovichka can make from plastic covers: