How to make a spinner made of paper
Do It Yourself / / December 19, 2019
There are hundreds of ways to make your own spinner, but most of them involve the use of the bearing. Layfhaker offers to make a fashionable anti-stress toy from the fact that it is always at hand.
What is needed
- Three sheets of paper of different colors.
- Rublev coin.
- Three-layer carton (can be replaced with foam or clay).
- Toothpick.
- Sharp knife or awl.
- Clerical glue.
Leaders in manufacturing
Cut a square of a sheet of paper. Double fold it in half in one direction and then rotate through 90 ° once more, and fold in half.
Bend the blank (only the last fold) and fold edges as shown below.
Do the same with the square of paper of a different color. As a result, you should get two such blanks.
Fold all corners of blanks, as shown in GIFCA.
The obtained preform post on each other crosswise.
Connect sheets vpravlyaya their angles to each other, as shown below.
You should have something like chetyrohkonechnoy stars. Do it in a hole right in the middle.
Measure out two circles on the cardboard with a coin. If you do not have the three-layer cardboard, improvise: instead you can use a piece of foam or linoleum, and can serve as a temporary replacement even clay. Do the holes in the center of the circles with a knife or toothpick.
Break toothpick, leaving only a segment of its thickest part (middle) finger length with thickness. Plug this segment in a circle of cardboard and glued. Pass the toothpick into the hole paper preform and close the second circle cardboard. Secure with glue. Remember that you need to stick a toothpick to the cardboard rather than paper blank.
Glue the circles to squares of colored paper and cut unnecessary on the circle line.
Spinner ready and turns almost like bearing.