5 simple ways to find out ring size

If you need to determine the size of the ring, but the hand is not a special device, do not despair. You will help the paper, string and a ruler.

method 1

Ring size corresponds to its inner diameter. Therefore, if you have a ring and you just do not know its size, measure the diameter of the line is sufficient.

method 2

Another option to find out the size using the available rings. Save and print the picture and attach the ornament to the circles. Ta, which coincides with an inner diameter, and prompt resolution.

Note: Print all pictures in full size (do not blend with the sheet size).

method 3

Take a thin strip of paper or a normal thread. Wrap around the bottom phalanx, close to the joint. Operate easily, without pressure, to the paper or the thread can slide on the finger.

In the case of a paper check the abutment handle. Then, cut a strip of label.

If you are using a string, wrap it several times, and then cut the resulting textile ring.

Print image below and attach the workpiece to a control line. The paper length or thread must correspond to the length of the colored strips.

method 4

The case where you come in handy mathematics knowledge. How do you remember to find the diameter (ring size), it is necessary to divide the circumference length of the number π.

How to apply this knowledge in life

Repeat the first board from the previous process, and then via line measure the length of paper strip or thread in millimeters. Divide the total by 3.14. Product or closest match (in accordance with the Russian measuring system) is the required size of the ring.

If the division is given is difficult, simply refer to the table. On the left contains the length of the string or strips of right - the appropriate size. Do not forget to round off your result to the nearest value.

process 5

Print the image, cut the workpiece, make her incision and insert the end of the line. You should get a paper ring. Adjusting it on a finger, you can find out the size.

recommendations

1. If you define the size of the narrow rings (5 mm in width), the result obtained by measurement may be rounded to the nearest value. For a wide rings (6 mm) rounded or add half a size.
2. The thickness of the fingers during the day may vary. Therefore it is better to make several measurements at different times of the day. Or once in the middle of the day: as a rule, at this time the man is at the peak of activity and fluid balance in the body the best.
3. Do not engage in measurements after drinking plenty of fluids, physical exertion or during illness. Also, do not do this, if the room is very hot or cold.

Do you know other ways to find out ring size at home? Share them in the comments.