11 cool Christmas crafts, which can handle every

1. winter candlestick

Put a candle inside and light. The light will fall like the windows of magical snow-covered houses.

What do you need

• bright paper;
• pencil;
• black marker;
• scissors;
• glue;
• glass jar;
• sponge;
• White paint.

How to do

Place a sheet of paper horizontally and draw on it contours winter city: snowdrifts, trees, houses with windows and lantern. Paint the figure with black marker and cut them along the contour. Do the windows of houses.

Now glue the paper along the bottom of the can. With a sponge lightly coat the glass and the city outline with white paint, simulating snow.

2. Christmas tree from the magazine

Two in One: decorate the house and get rid of old prints.

What do you need

• magazine;
• glue gun;
• gold spray paint;
• red and gold glitter foamiran or red and gold paper with glitter;
• pencil;
• scissors;
• beads.

How to do

Put the magazine so that the root was left. Take the first sheet, connecting the upper edge to the left. Lower right corner to the middle bend.

In the same way be straightened with the other sheets. Open the magazine about the middle and walk along the fold glue gun. Fold the right sheet edge gluing it to the middle of the magazine.

Swipe adhered part, again cover with adhesive and glue the center of the magazine next sheet. Similarly, did the same with the other sheets. You will have a cone. Cover it with spray paint.

On the reverse side foamirana or paper, draw two identical large gold star and some red and gold stars less. Carefully cut them.

Connect the two large stars out glitter and glue to the top of the tree. Place on New Year's tree, the other stars and beads.

3. Santa Claus from tin

What do you need

• double sided tape;
• can;
• Beige foamiran;
• scissors;
• colored cloth;
• glue gun;
• white artificial fur;
• blush;
• broad brush;
• white felt;
• black paint;
• White paint;
• brush;
• gold ribbon.

How to do

Stick the tape at the bottom, top and middle banks. Wrap foamiranom cylinder and cut off the excess. Glue the edges foamirana bilateral adhesive tape.

Wrap around the top of the jar colored cloth and apply the gun. Wrap the inside edge of the narrow strip of fur and glue. Place the resulting strip along the top of the jar.

Rouge cheeks draw Santa Claus. From the white felt cut mustache, and from the remnants of beige foamirana - round nose. Glue them to the bank.

Black and white paint, draw eyes. Glue on top of the eyebrows of white felt. Wrap the ribbon around gold colored fabric and tie a beautiful bow.

4. Wreath of paper napkins

Such beauty can be put on a table or mounted on the wall.

What do you need

• 5 round openwork paper napkins;
• pencil;
• line;
• scissors;
• glue;
• cardboard;
• White paper;
• glue gun;
• small artificial fir branches with cones;
• artificial red berries;
• White paint;
• brush;
• red bow.

How to do

Cut each of the three napkins into four equal parts and roll them into cones, brushing the edges with glue.

Cut out of cardboard circle diameter of 10 cm. Coat it with glue on one side and stick to the white paper. Cut a circle of it, departing from paperboard edges 1-2 cm.

Make vertical cuts on paper. Lubricate the paperboard edge of the circle from the reverse side with adhesive and stick to it the pre-cut paper.

Glue the circle of whole cloth on both sides. Mark the middle to the one that appeared on the front of the workpiece. With glue gun position on a circle of prepared cones napkins.

In the center of the wreath glue spruce twigs and berries. Lightly coat of white paint, simulating snow. Under the composition, place the bow.

5. New vase

This hack can be used as a stand for writing instruments and cosmetics, as a candlestick or just a beautiful decor element.

What do you need

• tetrad paper sheets;
• glue;
• glass beaker;
• scissors;
• glue gun;
• gold spray paint;
• twine;
• wooden decorative elements.

How to do

Twist sheet diagonally in a thin tube, periodically lubricating paper glue. Attach to the glass preform vertically and cut at approximately its height.

Make as many tubes so that you can cover the entire glass. It is better if they will be slightly different in length.

Attach them to the glass using a glue gun. Cover future vase painted inside and out. Wrap the lower and upper pieces of twine and glue in the middle of wood inlay.

6. Christmas gnome fabric

The cozy decor element in the Scandinavian style.

What do you need

• blank of foam in the shape of a cone;
• colored cloth;
• scissors;
• glue gun;
• white artificial fur;
• wire;
• gray fleece;
• black felt;
• wooden bowl;
• Christmas decoration.

How to do

Wrap the cone cloth, cut off the excess and glue using glue gun. Fur beard cut in the form of elongated rhombus and a long mustache, similar to the letter "L".

Glue the beard to the cone. It should cover a large part of it. Upstairs spread the fur and put a mustache to them hung a little beard. So the figure will be more volume.

Cut a piece of wire around the length of the cone and insert it into the top of the workpiece. Wrap the wire around the fleece so that it came on a little beard. Cut off the excess, connect fleece with a cone and seal the edges of fabric glue.

Of felt, cut eyes and glue them under the bonnet. Below are the nose gnome - wooden ball and a hat on a stick Christmas decoration.

Cute gnomes can be made from scrap materials. This video shows how to make them out of socks:

7. Toy of the bottles

When looking at this decoration you can hardly guess, from which it is made.

What do you need

• stationery knife;
• 2 plastic bottles of 1.5 liters volume;
• yellow paint;
• brush;
• wire;
• 6 fir-tree balls;
• PVA adhesive or acrylic adhesive;
• gold glitter;
• glue gun;
• red streamer;
• 3 red bow;
• decorative flower with sparkles.

How to do

Cut the bottle a little bit above the middle. In the center of each lid office knife to cut a hole. Cover the lid and close the yellow paint of the bottle.

Insert a piece of wire in the lid so that its ends are in bottles, and on top of a loop. Pull on each end of the three balls and tighten the wire. Balls should be inside the bottles.

Coat the outside of the bottle and cover with glitter glue, leaving a small strip along the bottom edge. To it via glue gun attach the narrow red band.

Glue together bows. Slightly twist the upper part of the wire above the bottle caps. With glue gun place close stranding bow, which glue decorative flower.

8. Volumetric snowman made of threads

If you insert into this nice snowman garland, it will decorate the room, even at night.

What do you need

• 2 balloons;
• Scotch;
• white yarn;
• scissors;
• PVA glue;
• water;
• needle;
• 2 thin wooden branches;
• glue gun;
• black double-sided paper or cardboard;
• color ribbon;
• colored cloth;
• 2 black buttons;
• cardboard;
• Orange paint;
• brush.

How to do

Inflate balloons and tie the ends. One ball should be slightly smaller than the other. Glue them with tape to form a snowman. Place tie gluing yarn to the balls placed closer to each other. Remains of cut thread.

In general the plate connect the glue and water in equal proportions. Thoroughly moisten the mixture and the resulting yarn tightly wound balls. The thread must cover a large part of their surface. Leave blank until dry. To speed up the process a little bit, you can use a hairdryer.

Pierce balloons in several places a needle and gently remove the rubber through the holes. Cut a little thread in the bottom of the snowman, so he could stand. Insert sprigs on each side - this will be his hands - and secure with glue gun.

To make the hat, cut a rectangle of black paper and glue the edges. You can also take a bush toilet paper and paint it black.

Cut out two circles of paper: the diameter of the resulting tube, and more. Less glue on top. Larger notch in the middle and connected to the lower part of the hat. The crown, wrap colored tape.

Grease the adhesive field hat and attach to the snowman head. Around the neck wrap rectangular piece of cloth, glue the edges to each other and to the lower bowl. Next to place buttons.

Make a small cardboard cone, paint it orange and glue in the middle of the upper ball. Of black paper cut mouth and eyes and place them next to the snowman's nose.

9. Volume tree from threads

This Christmas Tree is made by the same principle as the volumetric snowman. But there are a couple important nuances.

What do you need

• blank of foam in the shape of a cone;
• film;
• writing pins;
• PVA glue;
• water;
• white yarn;
• beads;
• glue gun.

How to do

Wrap the foam foil and pierce in several places with pins. Thanks to the film will be easier to remove the workpiece, and the pins will help hold the yarn in place.

Connect glue and water in equal proportions and mixed thoroughly moisten yarn. Wrap preform thread, meshing of their pins. Leave overnight to completely dry tree.

Remove the needle and gently remove the preform. Place on top of the beads using a glue gun.

10. New crescent

An unusual variant of the usual Christmas wreaths.

What do you need

• jigsaw and / or a pair of scissors;
• plywood or cardboard;
• twine;
• PVA glue;
• sponge;
• White paint;
• 2 bumps;
• wooden decorative snowflake;
• glue gun;
• small artificial spruce twigs;
• silver Christmas tree ball;
• white decorative ribbons with pompons;
• silver artificial berries;
• brush;
• wooden beads.

How to do

Using scissors or jigsaw cut from plywood or cardboard blank in the form of a crescent. Top, do a small hole and insert there a piece of twine - a future loop.

Gradually lubricating the workpiece glue, tightly wrap it twine. Apply with a sponge on the rope and the bumps a little white paint, simulating frost. Wooden snowflake dye completely.

Use the glue gun, attach the snowflake to the bottom of the crescent so that most of it peeking over the edge.

Near paste spruce twigs, and on them - bumps and ball. Place the braid with pompons and berries.

a little touch up twigs white paint With the help of a brush. The twine that is threaded into the upper hole, insert a wooden bead and tie knotted thread top and bottom.

11. Christmas tree from ribbons

What do you need

• pencil;
• White paper;
• scissors;
• green cardboard;
• stapler;
• red streamer;
• green narrow ribbon;
• White narrow ribbon;
• glue gun;
• foamiran pink glitter or pink paper with glitter;
• gold glitter.

How to do

Make white paper template, as shown in the video. Attach it to the green cardboard, and cut out the circle. Fold in half the workpiece and seal the bottom of the stapler.

Cut strips of tape 12 cm long and glue the edges of each of them. Attach them to the blank circle: lower row - red, the next - the green, then - the red, green, red and white.

Cut out paper foamirana or two identical stars, glue them and place on top of the Christmas tree. Sprinkle glitter Christmas crafts.